Lutron RadioRA 3 · Dubai & UAE
RadioRA 3 is the answer for a property that is already finished. It carries Lutron's dimming quality & shading control over Clear Connect RF, so a villa or apartment gains proper lighting scenes and automated blinds without chased walls, lifted marble or a family moving out for a month.
We install RadioRA 3 across Dubai's villas, penthouses & apartments — including occupied homes in towers, where we coordinate access & method statements with building management as a matter of routine. Lutron approved, programmed in-house, supported for life under Iconic Care™.
Wireless dimmers, keypads & shades go in behind existing plates & pelmets. Most villas are done in days, not weeks, and the interior is handed back as it was found.
RadioRA 3 is wireless, not compromised. The dimming curves, the silence & the fitting compatibility are Lutron's — the difference is how the signal travels, not how the light behaves.
Battery & wired Lutron shades on the same system as the lights. Sheers for glare, blackouts for bedrooms, scenes that move both together as the sun crosses the glass.
Sunnata keypads & dimmers in finishes matched to the interior, engraved with the scenes the household actually uses. Nothing that reads as retrofitted.
Full-height tower glazing, finished fit-outs & building-management coordination are routine work for us — including a Downtown Dubai residence delivered exactly this way.
RadioRA 3 scales cleanly. Start with the living spaces & the worst glare, extend later without replacing what is already installed.
What we work with
Questions
Indicatively AED 2,550 to 5,100 per lighting zone, with shading priced per opening on top. A living & dining retrofit is a very different number from a whole villa — our cost guide publishes the ranges honestly, and the exact figure follows a survey.
Yes — that is what it is for. Wireless dimmers & keypads replace existing plates, and battery shades need no new cabling. We survey first, plan around the household & coordinate with building management where a tower requires it.
HomeWorks is wired, processor-based & built for large or complex properties specified from the drawings. RadioRA 3 is wireless & built for properties that already exist. The light looks the same; the architecture behind it does not. We have written a full comparison in the Journal.
In almost every case, yes — Clear Connect runs on its own frequency rather than competing with Wi-Fi, and repeaters extend it where a villa's structure demands. We survey the property rather than assuming, and tell you honestly if a hybrid approach is the better answer.
Yes. RadioRA 3 integrates with Control4 so lighting & shading join climate, AV & security on one interface, with scenes that run across all of it.
